50W-06C (°C)
Max/Min temperature memory, thermometer clock module with Hi/Lo temperature settings
This is a thermometer clock module with Highest/Lowest temperature setting, and memory of both measured highest and lowest temperature. The physical sized as 70 x 51.3 mm. The LCD panel is covered by a 58 x 40 mm plastic frame. The LCD screen size is 49.3 x 22.3 mm, with digit height as 16 mm.
It is powered with a piece of lithium battery, CR2015. Operated with three tact s/w. The measuring range of temperature is from -10°C to +50°C with 0.1°C resolution. The accuracy can reach to +-1°C within the range of 0°C~50°C, and +-2°C for other ranges.
Low power detector circuit is built-in too. The module is featured with Hi/Lo setting and memory of max/min temperature. It provides control output and beep alarm for the measured temperature reading over or below the setting numbers.
It is good for either consumer or industrial applications.
It is powered with a piece of lithium battery, CR2015. Operated with three tact s/w. The measuring range of temperature is from -10°C to +50°C with 0.1°C resolution. The accuracy can reach to +-1°C within the range of 0°C~50°C, and +-2°C for other ranges.
Low power detector circuit is built-in too. The module is featured with Hi/Lo setting and memory of max/min temperature. It provides control output and beep alarm for the measured temperature reading over or below the setting numbers.
It is good for either consumer or industrial applications.
Specifications
- Physical Size:
- Frame Size - 50 x 40 mm
- Thickness: 10 mm (battery holder not included)
- LCD
- Screen Size: 49.0 x 21.9mm
- Number of Digit: 4 digits
- Digit Height: about 16.00 mm
- Measurement Range: -50°C to +125°C
- Accuracy: 0oC ~ +80oC ±1°C; others ±2oC
- Resolution: 0.1°C
- Electrical Specification:
- Power Source – 3.00 volts; 1 pc of Lithium battery, CR2025
- Low Voltage Alert – Low battery symbol displayed when voltage less than 2.4 volts
- Operating Voltage – +2.40 ~ + 3.60 volts
- Hi/Lo temperature setting with alarm and RS232 output (option)
- Memory of maximum and minimum temperature
Features
- Normal Display Mode
- clock,
- temperature,
- clock and temperature alternatively
- Buttons:
- SET – At clock mode, press to enter setting of hour and minute. While at temperature mode, press to setting of Hi/Lo temperature.
- MODE/ADJ – Press to change display mode normally; or at setting mode press to adjust hour/minute or Hi/Lo temperature.
- RESET – Press to reset system
